Pknight ArtNet to SPI DMX Controller WLED | Ethernet LED Controller 2048 Pixel 512 DMX Channel Node

Product description1 Network Setup2 Wiring Instructions3 WLED Preset Setup4 More detailsQ1: Can this controller operate both DMX fixtures and pixel LED strips simultaneously?A1: Yes. The PK-WLED-ASD1M supports simultaneous output of SPI and DMX signals. You can assign separate Universes or channels via the web interface, allowing one device to control both types of lighting in a hybrid setup.Q2: Does the controller require a WiFi connection to function?A2: No WiFi needed. It uses a wired RJ45 Ethernet connection for stable performance, which is ideal for stage, event, or installation environments where signal reliability is critical. Just connect it to a router, switch, or directly to your PC.Q3: Can I run lighting effects without using a computer or lighting software?A3: Yes. In Local Control Mode, you can configure and save your favorite effects (e.g. Rainbow, Android) directly in the web interface. These presets will automatically run when the controller powers on—no external control required.Q4: How many LEDs can this controller support?A4: For SPI output, up to 2048 channels are supported—around 680 RGB pixels. For DMX, the total must stay within 512 channels, depending on fixture channel usage.Q5: I’m new to lighting control—Is setup and operation difficult?A5: Not at all. The controller features an intuitive web-based configuration panel (default IP: 192.168.1.10) where you can easily adjust LED type, count, color order, and control mode. It also includes a hardware reset button for quick recovery.