SOMMER 434.42MHz 868.35MHz 2CH Receiver 9-250V 300-900MHz 2 Channel Momentary Relay Module for Garage Gate Opener Controller

HIGHLIGHTS[ Multi-frequency ] - Suitable for remote controls with different frequencies from 300-900MHz.[ Multi-brand ] - Suitable for most remote controls in the global market.[8 Dip Switches ] - Use of dip switches, corresponding to different brands, different frequency remote control[Dual Channel] - One channel is connected to the motor, the other channel can be used for lights[AC DC 7-32V AC 85-250V] - covers different voltage ranges 9V 12V 24V 32V 110V 210V 220V 230V 250V[Self-contained small antenna] - 20-100m long-distance control (subject to the environment, the effect may be worse)[Clear All Codes with One Click] - You can clear all learned remotes on the receiver with one click!Working frequency: 300-900MHz(Rolling code & Fixed code)300MHz310MHz315MHz318MHz390MHz433.4MHz433MHz433.92MHz868MHz868.3MHz868.8MHzCan identify ALL Fixed code (2262, 2260, 2264, 5326, M1E, M5E and so on). All Learning code (1527, 2240, 6P20B, 6P20D and so on), Rolling code (HCS301, HCS300,HCS200, HCS201, HCS100, HCS101),Specifications:1)Name: Universal receiver SMG-662.2)Operating Voltage: 9V-30V AC 85-250V3)Channel: 2.4)Frequency: 300MHz - 900MHz.5) Distance: 30-50 meters.6) Very mini size: 5.5cm4.5cm1.0cm.7) One receiver can work with 400 codes.8) It don’t interference other remotes and receivers.9) Brand selector: With 8 dip switches user can make different combination for different remote brands.10)Code: Rolling and Fixed code & Learning code.11)Uses: Receiver is designed to control any gate automation system, burglar alarm system, electric doors, windows, lifting equipment, gateways, lifting devices. This is an easy to use, good looking, low power consumption and is easy to connect to your existing system.Programming a new remote1) Select the correct brand for remote to be programmed by moving dip switches UP or DOWN. For example 433,92Mhz Marantec remote controls, just move Dip-switch 7 UP. 2) Press the learn button. The will LED turn on. 3) Press the button on the remote, the LED flashes 4 times. It means that remote control was programmed successfully. 4) Repeat step 2 for another button.5)The 2-nd channel programming procedure is the same. Erase all data from the memory card: Press and hold either learn button. The LED will start flash. Keep this button pressed, until the LED will turn off. All saved data in the memory card will be erased permanently and can not be recoveredConnect your motor or your controller to useReplacing old garage control systems, or for adding more remotes to control garage doorsAvailable for different brands, using different dialing arrangementsSuitable for a wide range of doorsGarage /Gate/Swing Gate/Barrier/Sliding Gate/...Work with 433MHz 1527 learning code remote controlIn order to better adapt to our receiver, it is recommended to choose to buy our remote controlNote: no battery include