SIXWGH | Wireless Switch RF 433MHz Remote Control Switch Push Button Relay Module Home Appliance Receiver for Lamp ON/OFF

SIMPLE WIRINGThe controller needs Live wire and neutral wire⭐Product introduction:Wireless switch: (The receiver is connected in series with the incoming line of the lamp, no wiring is required for the wireless switch, one receiver can be connected to 15 wireless switches);When the receiver is connected to the incoming line of the electrical equipment, it can be controlled wirelessly with a stick switch or a remote control.A receiver can match multiple random wireless switches at the same time, so that one electrical device can be controlled in multiple places!Solve the problems that there is no switch at the head of the bed, the lights are turned on at night, the circuit design is unreasonable, the height of the switch for the elderly and children at home is not suitable, and the wiring in the home is aging and inconvenient. After a power outage, the power will be self-extinguishing to avoid wasting electricity.⭐⭐⭐ Receiver parameters:Voltage: 100~250V, 50-60HZCurrent: 10AWorking frequency: 433.MHZSize: 72x38x26mmMode: ASK, EV 1527⭐⭐⭐ Wireless switch parameters:1, working voltage: DC 3V2, working frequency: 433.MHZ3. Transmitting power: 4, modulation method: ASK ， EV 15275, size: 86 * 86 * 11.5(mm)Fluorescent sticker design, glow at nightAdvantage:⭐⭐⭐ Remote control distance 20-80m⭐Can control 1 light from 15 different positions⭐Luminous fluorescent strip⭐Middle of the night, do not worry about finding the switch⭐Caring for family members⭐Never worry about getting up and turning off the lights in winter⭐Feel free to place, multiple fixing methodsany placement + double-sided adhesive fixing + screw fixing⭐⭐How to match the wireless tact switch with the controller:The product has been paired before leaving the factory and does not need to be paired again. If you need to replace or add a remote control switch, you can refer to the following steps:⭐ Pairing method:Press and hold the controller button for 3 seconds, the indicator light flashes, and enter pairing mode. At this point, press the wireless switch button twice, the controller is controlled, and the pairing is successful.⭐How to clear match :Press and hold the controller button for 10 seconds, the controller indicator flashes twice, and the is cleared successfully (note: do not press the wireless switch at this time)⭐⭐⭐⭐⭐Note：1. professional electrician should operate this product. When powering on, do not touch the antenna. Install this product without opening the protective cover2. Do not operate with power. Turn off the power supply and operate it. If the test is confirmed to be correct, use it under the guidance of a professional electrician.