ATA PTX5 PTX5V1 PTX5V2 GDO 11v1/6v3/6v4/7v2/7v3/8v3/9v2/9v3 Garage Door Remote 433.92MHz Rolling Code Transmitter

ATA PTX5 PTX5V1 PTX5V2 GDO 11v1/6v3/6v4/7v2/7v3/8v3/9v2/9v3 Garage Door Remote 433.92MHz Rolling Code TransmitterDescription:1. Type of programming: Programming with the receiver2. Number of channels: 43. Code: rolling code4. Frequency: 433.92 MHz5. Battery: CR20326. Size: 703013mmSuits remote models: PTX5 PTX-5PTX5PTX5V1PTX5V2DCB-05 (Dual Gate Controller)GDO-6v3 (EasyRoller)GDO-6v4 (EasyRoller)GDO-7v2 (SecuraLift)GDO-7v3 (SecuraLift)GDO-8v3 (Shed Master)GDO-9v2 (SecuraLift)GDO-9v2 (Enduro)GDO-9v3 (Dominator)GDO-9v3 (Dynamo)GDO-10v1 (Toro)GDO-11v1 (Ero)NES-24v1 (NeoSlider)SGO-1 (Elite)As a general guide, if the remote you currently use is one of the remotes pictured in the ad then this remote will be copy with your remote.If you are not so sure, please contact us without hesitate.Programming transmitters to receiverThe remote control is the same function as your original remote.it should programming with original receiver according to your original Manual when you get it.1. Locate the Learn / Code Set button on the motor. This is usually under the lamp cover, or on the back of the motor.2. Press the Learn / Code Set button once, then let go. A light should illuminate.3. Press the desired transmitter button once, and the light will go out.4. Press the remote again the the light will flash on the motor and then go out, signifying the remote has been coded.5. Test the operation of the remote.Include* Remote Control* Battery* English Manual