Remote Control For ATA PTX5v2 PTX5 PTX2 PTX 2V1 2V2 5V1 TrioCode 433.92MHz ATA PTX5 Garage Door Opener

ATA PTX5v2 PTX5 PTX2 PTX 2V1 2V2 5V1 Garage Door Remote Control TrioCode 433.92MHz ATA PTX5 Garage Door OpenerCompatibility PTX5V1 PTX5V2NOTE - NOTE - NOTE, 【does not suit the PTX4 remote controls as they are an older series of remote control.】---Roller Door MotorsGDO6v3 EasyRollerGDO6v4 EasyRollerGDO8v3 ShedmasterGDO10v1 ToroGDO10v2 ToroGDO10v3 ToroGDO12 HiroAnd all other compatible TrioCode receivers and motors---Sectional Door MotorsDCB-05 (Dual Gate Controller)GDO7v2(SecuraLift)GDO7v3(SecuraLift)GDO9v2(SecuraLift)GDO-9v3 (Dynamo)GDO9v3(Dominator)GDO-10v1 (Toro)GDO11v1(Ero)Tempo ATS-2And all other compatible TrioCode receivers and motor---Gate MotorsSGO-1 (Elite)SGO1v3 EliteSGO1v4 EliteNES24v1 NeoSliderNES24v2 NeoSliderNES24v3 NeoSliderNES500 NeosliderNES800 NeoSliderAnd all other compatible TrioCode receivers and motor---Industrial OpenersAxess Pro Series 3100 (Logic Console Only)Axess Pro Series 3300 (Logic Console Only)Axess Pro 1505 OverheadAxess Pro 600 SliderAxess Pro 800 SliderAxess Pro 200 SwingAxess Pro 400 Swing---ReceiversFHCRX1 Single Channel ReceiverFHCRX1v2 Single Channel ReceiverFHCRX2 Dual Channel ReceiverFHCRX2v2 Dual Channel ReceiverFHRX2 Plug-In Board ReceiverAccess to receiver required. Please make sure you got access to your receiver/opener before purchase.Disclaimer: Your remote control must be the same as the picture and your model must be in the list, we will not be responsible for wrong purchaseDescription:1.Type of programming: Programming with the receiver2.Number of channels: 43. Code: rolling code4. Frequency: 433.92MHz5.Woring Range: 10-50 m (open space) 6.Remote come with Battery !!!Feature1. Free Battery2. Free Coding Instructions3. Free Keychain4. Mini Design5. In-built Battery6. Button ProtectorProgramming transmitters to receiverThe remote control is the same function as your original remote.it should programming with original receiver according to your original Manual when you get it.1. Locate the Learn / Code Set button on the motor. This is usually under the lamp cover, or on the back of the motor.2. Press the Learn / Code Set button once, then let go. A light should illuminate.3. Press the desired transmitter button once, and the light will go out.4. Press the remote again the the light will flash on the motor and then go out, signifying the remote has been coded.