433mhz 433.92MHZ Universal Garage Receiver For ROGER ALUTECH AN-MOTORS AT-4 Gate Door Remote Control

433MHz Universal Garage Receiver 2CH DC 12-24V Rolling Code Learning Code Fixed CodeDescription1. Power supply: 12V-24V DC2. Frequency: 433.92MHz 433MHz3. Codes:Fixed/Learning/Rolling Code4. 2 Channel5. Working temperature :-40℃- + 80℃6.Built in Aerial antenna : Reception range 30-100mCompatible with multiple brandssuch as:AT-4AprimaticATA PTX4CARDINCrawfordDOORHANFLORSPRASTELProduct Description1) Can learn Fixed and Rolling code 433,92Mhz remote controls separately and simultaneously !!!2) 2 channel receiver provides you with an option to control and use 2 gate automations or alarm systems simultaneously 3) This receiver can be used in cases, when your original receiver's memory is full and can't accept any additional remote controls. By connecting this receiver to your system, you can increase the ammount of remotes up to 400. So 400 remote controls can be added to your existing system. 4) This receiver can be used in case, if you need to add more additional remote controls. The original remote controls cost is quite expensive. By connecting this receiver to your system you will save a lot of money, especially if you require 10-20 or more additional remotes. 5) If you have few different remote controls from different systems, you can replace them (substitute) with 1 4-channel remote!!! It's very handy to use 1 remote instead of 3 or 4.6) It's very easy to connect it to your control board. All you need is to connect 4 wires between receiver and control panel. If you will need any technical support - i'm always at your service!ProgrammingMomentary working model:1.Learning transmitter’s codes:Press “learn 1” or “learn 2” for 1 second, the “learn_led” light, then, press the button which you choose on the transmitter till the “learn_led” flash and go out, the transmitter’s code has been stored.• Repeat the above steps for other transmitters.2.Erasing transmitter’s codes:Press “learn 1” or “learn2” and hold on to make the “learn_led light till go out, all codes of transmitters which had been stored are erased.ANT - Receiver AntennaCH1 - Relay Output 1CH2 - Relay Output 2V+ - Voltage +GND - GroundSpecifications Of The Remote Control:Operating frequency: 433MHzPower by 23A 12V (Battery not included ),Material: PVC.Button: 4 buttonsEncoding type: Learning Code.Transfers distance: 20-50mRemote Control:No battery