Brushless Motor Submersible Pump DC 12/24V Shower Booster Pump Filtration Pump 1000L/H 8M Head G1/2 External Thread

If the water pump is not equipped with a transformer, it cannot directly use 220V AC voltage!If the 220V AC voltage is directly connected without a transformer, the water pump will be damaged!Note:This DC brushless centrifugal pump exhibits reduced flow rate as the pumping head increases.It is not equipped with self-priming capability and shall operate submerged.For on-land application, the pump chamber must be pre-filled with water to work properly. Operation without water (dry running) is strictly prohibited.100% brand new and high qualityFeatures:This DC pump uses advanced electronic components and high-quality wear-resistant shaftIt is smooth operation, high efficiency, good performance, long service life,Can be a long time continuous work, low noise, safety and environmental protection.It is widely used in industry, scientific research, aerospace industryUsage:Connect the DC female connector of the water pump to a suitable power adapter, then attach a good water pipe, and finally put the water pump into the water. Then it can be used normally.If the pump is in the land mode, it needs to be placed below the horizontal level and the water should be introduced into the pump's interior. Only in this way can it work properly.Specification:Name: Water pumpColor: BlackPower: 30WVoltage: DC 12/24VInlet/Outlet: G1/2" male theadMax Flow Rate: 1100L/HMax Horizontal Delivery: 8MWaterproof rating: IP68Working noise: ≤35dBDC female connector specification: 5.5x2.1mmMax circulating water temperature: 100°COperating environmental temperature: 0~80°COperating environment humidity: below 90% RHPump shaft assembly: Ceramic shaftShaft material: Ceramic shaft1Material of the pump housing: PA66 + 30% glass fiberUsage medium: Water, alcohol, diesel and other liquids with good fluidity.Note:1.To use the land-based mode, water must first be introduced into the inlet before it can operate normally.2.It is prohibited to connect the pump to a 220-volt power supply without a power converter.3.Is strictly prohibited for strong acidity, alkali and other damage to the pump medium.4.The pump is suitable for medium temperature 0 ℃ -100 ℃.5.It is strictly prohibited to use in liquids containing impurities larger than 0.35MM and magnetic conductive particles. If the water quality is too dirty, the impurities in the pump chamber should be cleaned promptly.6.It is strictly prohibited to run the machine without water for an extended period.